Affordable Auto LED Blog

Posts Tagged ‘rear seat map lights’

Here’s what you’ll need:
For the Chargers, you will need the following bulbs.
(2) 44mm rigid loop, 9 LED Festoon bulb (front map lights)
(2) 194 SMT tower LED (rear seat map lights)
(1) 44mm rigid loop, 9 LED Festoon bulb (rear trunk light)
(1) 194 4-star SMT (rear exterior license plate light)

There is no courtesy lights and glove box lights for the Dodge’s. But you can order the glove box light and install in your glove box.
Then you will need a: (1) 194 SMT tower LED (glove box)

Rear seat map lights (similar to the front map lights)

1. From the click on/off end of the clear lens. Use a small jewelry/glasses flat head screw driver. Carefully wedge it into the on/off end of the lens and pry that end of the lens down. It may seem like it will snap, don’t worry. The other end of the lens has a tab on it and simply pull the lens, after popping it from the on/off end and it will come out.

2. You should now see the oem 194 bulb and a rear reflector.

3. I use the small flat head to pop the 194 bulb out. I have a towel in the other hand to catch the hot 194 LED bulbs.

4. Do not remove the rear reflector on the rear map lights.

5. Before installing the 194 tower SMT bulbs. Go to the socket prongs that hold the bulb in place. When you remove the oem 194 bulbs, the prongs tend to un-bend a bit. So take your fingers and lightly re-squeeze them a bit tighter.

6. Once the new 194 LED is installed. Flick it a few times to make sure it stay on. If it doesn’t. Pull the led bulb out and re-squeeze the socket prongs. Once the light stays on. Re-install the clear lens.

7. Take the end of the lens with the wedge on it and insert that into place. Then push in the on/off click end and you are done.

We found this useful information from chargerforums.com and to shop LED bulbs, please visit us at www.LEDoption.com, the cheap LED bulbs store.